• The Power-lift of this PL-65 High Speed Hydraulic Jack Plate 65302 is totally waterproof!
• Marine electric hydraulic system  of this CMC High Speed Hydraulic Jack Plate 65302 is made of 100% non-ferrous material for corrosion resistance in any water.
• The hydraulic actuator of this High Speed Hydraulic Jack Plate 65302 is completely self-contained with its own fluid reservoir (hydraulic tank and hoses inside the boat are not necessary).
• The magnet motor of this  Hydraulic Jack Plate 65302 is permanent for additional power and R.P.M.
• The 2" diameter cylinder within the actuator has twice the lifting capacity than most other transom jack plates on the market.
• This High Speed Hydraulic Jack Plate 65302 eliminates vibration and shimmy due to loads applied from high power outboards.
• The hydraulic actuator of this Hydraulic Jack Plate is mounted inside the structure of the Power-Lift, yet it is fully accessible without removing the engine.

PL-65 High Speed Hydraulic Jack Plate Features:

Introducing *New*Features Of Patented CMC Hydraulic High Speed Power-Lift Jackplate Full Stroke in 8 seconds!

The CMC PL-65 High Speed Jack Plate is rated for V-6 engine and smaller applications. Provides you 5" of vertical travel with 1-1/2" of adjustment on the motor bracket and 1-1/2" of adjustment on the transom bracket. It also can be purchased with stainless steel motor rails, Model PL-65SS (for V-8 motors 300 HP MAX).      

  "A TOTAL OF 8" OF POSSIBLE ADJUSTMENT! 

• Gives 5 1/2 inches of setback from the transom.
• Made of 3/4 and 1/2 inch 6061 T6 alloy aluminum extrusions and fastened with stainless steel fasteners. No welds or castings to break.
• The dependable self contained and water proof high speed hydraulic actuator has a maximum lifting capacity of 4417 pounds of thrust. You will have no problem lifting even a V-6 300 hp maximum motor at full throttle.
• The patented roller design means less friction, longer wear, less maintenance, and virtually no binding problems which are common with other boat transom jacks.
• The roller assembly contains a stainless steel 3/4" pin with aluminum-bronze alloy rollers. The roller is highly impact resistant, corrosive resistant, and has a high load carrying capacity.
• Increases fuel efficiency.
• Hydraulic jack plates are useful when it is necessary to get a boat on or off plane in shallow waters.
• Designed to fit standard B.I.A. bolt pattern without drill holes or making modifications in the boat or motor
• All the necessary electrical components for installation are included.
• Easily adjustable from top or bottom.
• Take a look at the wiring for the PL-65.
• Get this item for your convenience.
• More Information: PL-65 CATALOG